Home / Dishwasher repair / Whirlpool / third-rack and standard tall-tub

Whirlpool third-rack and standard tall-tub dishwasher repair

Whirlpool built-in dishwashers, many sharing their design with KitchenAid, Maytag and Kenmore models. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.

From our service calls

What fails on the third-rack and standard tall-tub

  • Filter and chopper

    Dishes come out dirty when the manual-clean filter is not rinsed.

  • Drain pump

    Water stays in the tub.

  • Heating element

    Dishes do not dry.

  • Door latch

    The dishwasher will not start.

In Charleston

Run the kitchen tap until the water is hot before starting the dishwasher, and use rinse aid to stop spotting.

Owner tip: Rinse the cylinder filter under the lower arm once a month.

Repairs

Common repairs for this dishwasher

On the display

Whirlpool dishwasher error codes

F2E2 Whirlpool · Dishwasher

User interface fault

Cause: The control panel is not communicating with the main control.

What to do: Switch off at the breaker for 5 minutes. If it returns, the panel or ribbon cable needs replacing.

Needs a technician Book a repair
F5E1 Whirlpool · Dishwasher

Door switch fault

Cause: The control did not see the door open and close.

What to do: Open and close the door firmly, then press Start. If it returns, the latch needs replacing.

You can check this yourself Book a repair
F6E3 Whirlpool · Dishwasher

Suds or air in the pump

Cause: Too much detergent, hand dish soap, or not enough water.

What to do: Use only dishwasher detergent and check the water supply is fully open.

You can check this yourself Book a repair
F6E4 Whirlpool · Dishwasher

Float switch open

Cause: Water in the base pan has lifted the overfill float.

What to do: Turn off the water supply. The leak must be found and fixed.

Needs a technician Book a repair
F7E1 Whirlpool · Dishwasher

No heat

Cause: The heating element or its circuit has failed.

What to do: The heater needs testing and replacing.

Needs a technician Book a repair
F8E1 Whirlpool · Dishwasher

Slow drain

Cause: The drain hose is kinked or the drain path is clogged.

What to do: Clean the filter, check the hose and the garbage disposal knockout plug.

You can check this yourself Book a repair
F9E1 Whirlpool · Dishwasher

Diverter position fault

Cause: The diverter that switches spray arms is not finding its position.

What to do: The diverter motor and sensor need testing.

Needs a technician Book a repair

All Whirlpool dishwasher codes

Call Book a repair