Home / Dishwasher repair / GE / built-in

GE built-in dishwasher repair

GE built-in dishwashers including the Profile line. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.

From our service calls

What fails on the built-in

  • Drain pump

    Water stays in the tub.

  • Circulation pump

    Weak wash and dirty dishes.

  • Door latch

    The dishwasher will not start.

  • Leak sensor

    The dishwasher stops and drains.

In Charleston

Run the kitchen tap until the water is hot before starting the dishwasher, and use rinse aid to stop spotting.

Owner tip: Run the kitchen tap hot before starting a cycle.

Repairs

Common repairs for this dishwasher

On the display

GE dishwasher error codes

C1 GE · Dishwasher

Drain is taking too long

Cause: Water took more than 2 minutes to pump out.

What to do: Check the drain hose, air gap and garbage disposal for clogs.

You can check this yourself Book a repair
C3 GE · Dishwasher

Will not drain

Cause: The dishwasher cannot pump the water out.

What to do: Clear the drain path. If it still won't drain, the pump needs service.

You can check this yourself Book a repair
C4 GE · Dishwasher

Too much water

Cause: The float switch is stuck or the dishwasher is overfilling.

What to do: Turn off the water supply. The float and inlet valve need checking.

Needs a technician Book a repair
C6 GE · Dishwasher

Water temperature too low

Cause: The incoming water is not hot enough.

What to do: Run the kitchen hot tap until it is hot before starting, and set the water heater to 120°F.

You can check this yourself Book a repair
C8 GE · Dishwasher

Detergent cup blocked

Cause: The detergent cup could not open.

What to do: Make sure dishes are not blocking the cup and clean any residue from it.

You can check this yourself Book a repair
H2O GE · Dishwasher

Low water

Cause: Not enough water is entering the dishwasher.

What to do: Check the supply valve under the sink is fully open.

You can check this yourself Book a repair
PF GE · Dishwasher

Power failure

Cause: Power was interrupted.

What to do: Press Start to resume or reset the cycle.

You can check this yourself Book a repair

All GE dishwasher codes

Call Book a repair