Pump operation fault
Cause: The circulation pump is not working correctly.
What to do: Switch off at the breaker for 5 minutes. If it returns, the pump needs service.
Home / Dishwasher repair / Samsung / built-in
Samsung built-in dishwashers, including the WaterWall and StormWash models. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.
From our service calls
Water stays in the tub with a drain code.
The dishwasher stops and shows a leak code.
The dishwasher will not start.
Dishes do not dry.
In Charleston
Run the kitchen tap until the water is hot before starting the dishwasher, and use rinse aid to stop spotting.
Owner tip: Clean the filter monthly and use only dishwasher detergent.
Repairs
On the display
Cause: The circulation pump is not working correctly.
What to do: Switch off at the breaker for 5 minutes. If it returns, the pump needs service.
Cause: The supply valve is closed or the inlet hose is kinked.
What to do: Open the supply valve under the sink and straighten the hose.
Cause: The drain hose is kinked or the filter and sump are clogged.
What to do: Clean the filter and check the drain hose and garbage disposal connection.
Cause: The moving reflector at the bottom is blocked or its motor has failed.
What to do: Make sure nothing is blocking the reflector track. If it returns, call a technician.
Cause: The control boards have lost communication.
What to do: Switch off at the breaker for 5 minutes. If it returns, call a technician.
Cause: The water is not heating.
What to do: The heater and temperature sensor need testing.
Cause: Water has reached the leak sensor in the base.
What to do: Turn off the water supply. If the unit was just installed, check the disposal knockout plug. Otherwise call a technician.
Cause: The water level is too high.
What to do: Turn off the water supply and call a technician.
Cause: The water distributor is not moving to position.
What to do: The distributor motor needs testing.
Cause: A control button was held too long or is jammed.
What to do: Dry the control panel and switch off at the breaker for a minute.