Water leak
Cause: Water has been detected in the base.
What to do: Turn off the water supply and unplug the dishwasher. The leak must be found.
Home / Dishwasher repair / LG / built-in
LG built-in dishwashers, including QuadWash models. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.
From our service calls
OE code and water in the tub.
AE or similar codes.
The dishwasher will not start.
Dirty dishes.
In Charleston
Run the kitchen tap until the water is hot before starting the dishwasher, and use rinse aid to stop spotting.
Owner tip: Rinse the filter once a month.
Repairs
On the display
Cause: Water has been detected in the base.
What to do: Turn off the water supply and unplug the dishwasher. The leak must be found.
Cause: Not a fault: the fan is running for 60 minutes after the cycle to dry the dishes.
What to do: Open the door or press Power to stop it.
Cause: Too much water entered the tub.
What to do: Turn off the water supply and call a technician.
Cause: The heater circuit has failed.
What to do: The heater needs testing and replacing.
Cause: The supply valve is closed or the pressure is low.
What to do: Open the supply valve fully and check the inlet hose.
Cause: The wash motor is locked or has failed.
What to do: Switch off at the breaker for 5 minutes. If it returns, the motor needs service.
Cause: The drain hose is kinked or the filter is clogged.
What to do: Clean the filter and check the drain hose and air gap.
Cause: Power was interrupted during the cycle.
What to do: Press Start to resume.
Cause: Hand dish soap or too much detergent was used.
What to do: Let the suds settle, then run a rinse. Use only dishwasher detergent.
Cause: The motor that switches spray arms has failed.
What to do: The diverter motor needs replacing.