Home / Dishwasher repair / Bosch / 100, 300, 500, 800 and Benchmark series

Bosch 100, 300, 500, 800 and Benchmark series dishwasher repair

Bosch built-in dishwashers, known for quiet operation and the condensation drying system. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.

From our service calls

What fails on the 100, 300, 500, 800 and Benchmark series

  • Drain pump

    E24 or E25 code and water left in the tub.

  • Leak protection

    E15 code when water reaches the base pan.

  • Heating pump

    E09 type codes and no heat.

  • Door latch

    Will not start.

In Charleston

Run the kitchen tap until the water is hot before starting the dishwasher, and use rinse aid to stop spotting.

Owner tip: Clean the filter monthly and use rinse aid: Bosch condensation drying relies on it.

Repairs

Common repairs for this dishwasher

On the display

Bosch dishwasher error codes

E01 Bosch · Dishwasher

Heating or control fault

Cause: The power module or heater circuit has failed.

What to do: Switch off at the breaker for 5 minutes. If it returns, the control module needs service.

Needs a technician Book a repair
E09 Bosch · Dishwasher

Heater fault

Cause: The flow-through heater has failed.

What to do: The heater is replaced, usually together with the pump.

Needs a technician Book a repair
E14 Bosch · Dishwasher

Flow sensor fault

Cause: The dishwasher can't measure the incoming water.

What to do: Check the water supply. If it returns, the flow sensor needs replacing.

Needs a technician Book a repair
E15 Bosch · Dishwasher

Water in the base pan

Cause: An internal leak has tripped the float switch — a hose, the pump seal or the sump.

What to do: Turn off the water supply and unplug the dishwasher. A technician has to locate the leak.

Needs a technician Book a repair
E16 Bosch · Dishwasher

Uncontrolled water fill

Cause: Water is entering when it shouldn't, usually a leaking inlet valve.

What to do: Turn off the water supply. The inlet valve needs replacing.

Needs a technician Book a repair
E17 Bosch · Dishwasher

Overfill

Cause: Too much water entered the dishwasher.

What to do: Turn off the water supply and call a technician.

Needs a technician Book a repair
E18 Bosch · Dishwasher

Water level too low

Cause: Not enough water is entering: closed valve, kinked hose or low pressure.

What to do: Open the supply valve fully and straighten the inlet hose.

You can check this yourself Book a repair
E22 Bosch · Dishwasher

Filter blocked

Cause: Food residue has clogged the filter at the bottom.

What to do: Twist out the filter and rinse it under running water.

You can check this yourself Book a repair

All Bosch dishwasher codes

Call Book a repair