Water level sensor fault
Cause: The level sensor or its hose is faulty.
What to do: The sensor needs checking by a technician.
Home / Washer repair / Samsung / top-load
Samsung top-load washers with an impeller, including the activewash models. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.
From our service calls
The washer stops with an unbalanced code.
The tub bangs during spin.
The washer stops before spin.
Filling stops too early or too late.
In Charleston
Lowcountry humidity means front-load door seals and dispensers mildew faster than in drier climates. Leave the door ajar between loads and wipe the seal weekly.
Owner tip: Load evenly around the impeller and avoid single heavy items.
Repairs
On the display
Cause: The level sensor or its hose is faulty.
What to do: The sensor needs checking by a technician.
Cause: The drive motor is overloaded or its sensor has failed.
What to do: Reduce the load and restart. If it returns, the motor needs service.
Cause: A faucet is closed or the inlet hose is kinked.
What to do: Open the faucets, straighten the hoses and rinse the inlet screens. If nothing changes, the inlet valve is faulty.
Cause: The hot water hose is connected to the cold inlet.
What to do: Swap the inlet hoses so cold water feeds the cold inlet.
Cause: The pump filter is full of debris or the pump has failed.
What to do: Drain the water through the emergency drain tube and clean the filter.
Cause: The supply voltage is too low or too high.
What to do: Plug the washer directly into a wall outlet, not an extension cord. If it continues, have the outlet checked.
Cause: The control boards have lost communication.
What to do: Unplug for 5 minutes. If it returns, the boards and wiring need testing.
Cause: The heater or its sensor has failed.
What to do: The heater needs testing and replacing if faulty.
Cause: Water has reached the leak sensor in the base, or the drain hose is pushed too far into the standpipe.
What to do: Check the drain hose is not sealed into the pipe and look for leaks. If it returns, call a technician.
Cause: The water level is too high: a faulty inlet valve or level sensor.
What to do: Turn off the water and unplug the washer. The valve and sensor need testing.