Door won't lock
Cause: The door lock assembly is faulty or something is caught in the latch.
What to do: Make sure nothing is caught in the door and close it firmly. If the code stays, the lock needs replacing.
Home / Problems / Washer / Washer won't start
A washer that does nothing at all is often a power, door lock or control lock issue before it is a failed part.
Most likely first
A tripped breaker or GFCI outlet leaves the washer dead.
The panel ignores buttons until the lock is held off.
The cycle will not begin until the lock is engaged.
Buttons beep but nothing runs, or the display stays dark.
The motor will not run after overheating.
In Charleston
Lowcountry humidity means front-load door seals and dispensers mildew faster than in drier climates. Leave the door ajar between loads and wipe the seal weekly.
Safe checks before you book
When to call us: Call us if the outlet works, no lock is on, and the washer still does nothing or shows a control code.
Repairs that fix it
Shows a code?
Cause: The door lock assembly is faulty or something is caught in the latch.
What to do: Make sure nothing is caught in the door and close it firmly. If the code stays, the lock needs replacing.
Cause: The lock can't engage, often because something is in the way or the lock has failed.
What to do: Check nothing is caught in the door or lid. If the code stays, the lock needs replacing.
Cause: The drive motor is overloaded or its sensor has failed.
What to do: Reduce the load and restart. If it returns, the motor needs service.
Cause: The door latch or lock is faulty.
What to do: Close the door firmly. If the code stays, the lock assembly needs replacing.
Cause: The motor is drawing too much current: overloaded drum or a motor fault.
What to do: Reduce the load and unplug for 30 minutes. If it returns, call a technician.
Cause: Not a fault: the control panel is locked.
What to do: Hold the Child Lock button for 3 seconds to unlock.
Cause: The drum is overloaded or the rotor position sensor is faulty.
What to do: Reduce the load and unplug the washer for 30 minutes. If it happens again, call a technician.
Cause: The door is not fully closed or the lock has failed.
What to do: Close the door firmly. If the code stays, the door lock needs replacing.
A washer that does nothing at all is often a power, door lock or control lock issue before it is a failed part.
Plug a lamp into the same outlet to test it and reset any GFCI. Look for a lock icon and hold the lock button for 3 seconds. Close the door firmly and check for clothing caught in the latch. Unplug the washer for a full minute to reset the control.
Call us if the outlet works, no lock is on, and the washer still does nothing or shows a control code.
One flat service call covers the trip and a full diagnosis. You get an exact quote for parts and labor before any work starts.