Too many suds
Cause: Too much detergent, or non-HE detergent in an HE washer.
What to do: Let the washer finish its rinse routine. Use only HE detergent and less of it.
Home / Appliances / Washer
From drum bearings to the control board, we fix every washer fault at your home, right in front of you.
| Repair | Typical time | |
|---|---|---|
| Drain pump replacementpopular | ~45 min · 3 mo warranty | |
| Drum bearing replacementpopular | ~150 min · 3 mo warranty | |
| Door lock / lid switch repair | ~40 min · 3 mo warranty | |
| Water inlet valve replacement | ~40 min · 3 mo warranty | |
| Control board repair | ~90 min · 3 mo warranty | |
| Drive belt replacement | ~30 min · 3 mo warranty | |
| Suspension and shock replacement | ~75 min · 3 mo warranty |
Every visit starts with one flat service call. After the diagnosis you get an exact quote for parts and labor, and you decide before any work starts.
Troubleshooting
Error codes
Cause: Too much detergent, or non-HE detergent in an HE washer.
What to do: Let the washer finish its rinse routine. Use only HE detergent and less of it.
Cause: The load has shifted to one side of the basket.
What to do: Open the lid, spread the laundry evenly and restart.
Cause: The main electronic control has an internal fault.
What to do: Unplug the washer for 2 minutes. If the code returns, the control board needs diagnostics.
Cause: The drain pump filter is clogged or the drain hose is kinked.
What to do: Unplug the washer, open the lower access panel and clean the pump filter. If the code returns, the pump needs replacing.
Cause: The water level sensor or its hose is faulty or disconnected.
What to do: The pressure hose and sensor need checking by a technician.
Cause: The door lock assembly is faulty or something is caught in the latch.
What to do: Make sure nothing is caught in the door and close it firmly. If the code stays, the lock needs replacing.
Cause: The main control and the motor control are not talking to each other.
What to do: Unplug for 2 minutes. If it returns, the wiring harness and boards need testing.
Cause: The motor can't reach the expected speed: overloaded basket, worn drive or faulty motor sensor.
What to do: Remove some laundry and restart. If it returns, the drive system needs service.