Home / Problems / Washer / Washer stops mid-cycle

Washer stops mid-cycle

A washer that stops partway is often waiting for something it cannot sense, like water draining, water filling or the lock.

Most likely first

Common causes

  1. 1

    Long fill or long drain

    The washer pauses and shows a code when a step takes too long.

  2. 2

    Unbalanced load

    The washer stops to try to rebalance.

  3. 3

    Overheating motor

    A thermal cut-out stops the motor until it cools.

  4. 4

    Loose wiring or failing control board

    Power drops out at random points.

In Charleston

Lowcountry humidity means front-load door seals and dispensers mildew faster than in drier climates. Leave the door ajar between loads and wipe the seal weekly.

Safe checks before you book

  • Note the exact step where it stops and any code on the display.
  • Check the drain filter and fill screens.
  • Run a smaller load.

When to call us: Call us if it stops at random points without a code or the display goes blank.

Repairs that fix it

What the technician may do

Shows a code?

Related washer error codes

F21 Whirlpool · Washer

Long drain

Cause: The drain pump filter is clogged or the drain hose is kinked.

What to do: Unplug the washer, open the lower access panel and clean the pump filter. If the code returns, the pump needs replacing.

You can check this yourself Book a repair
LF Whirlpool · Washer

Long fill

Cause: Water is entering too slowly: faucets partly closed, kinked hoses or clogged inlet screens.

What to do: Open both faucets fully, straighten the hoses and clean the inlet screens.

You can check this yourself Book a repair
uL Whirlpool · Washer

Unbalanced load

Cause: The washer is trying to rebalance the load.

What to do: Let it finish. If it stops, redistribute the laundry by hand.

You can check this yourself Book a repair
3C Samsung · Washer

Motor fault

Cause: The drive motor is overloaded or its sensor has failed.

What to do: Reduce the load and restart. If it returns, the motor needs service.

Needs a technician Book a repair
5C Samsung · Washer

Water is not draining

Cause: The pump filter is full of debris or the pump has failed.

What to do: Drain the water through the emergency drain tube and clean the filter.

You can check this yourself Book a repair
OC Samsung · Washer

Overfill

Cause: The water level is too high: a faulty inlet valve or level sensor.

What to do: Turn off the water and unplug the washer. The valve and sensor need testing.

Needs a technician Book a repair
Ub Samsung · Washer

Load is unbalanced

Cause: The laundry has bunched to one side or the washer is not level.

What to do: Redistribute the load and adjust the leveling feet.

You can check this yourself Book a repair
CE LG · Washer

Motor overcurrent

Cause: The motor is drawing too much current: overloaded drum or a motor fault.

What to do: Reduce the load and unplug for 30 minutes. If it returns, call a technician.

Needs a technician Book a repair
01Why is my washer doing this?

A washer that stops partway is often waiting for something it cannot sense, like water draining, water filling or the lock.

02What can I check myself first?

Note the exact step where it stops and any code on the display. Check the drain filter and fill screens. Run a smaller load.

03When should I call a technician?

Call us if it stops at random points without a code or the display goes blank.

04What does a repair visit cost?

One flat service call covers the trip and a full diagnosis. You get an exact quote for parts and labor before any work starts.

Call Book a repair