Hot water sensor fault
Cause: The domestic hot water temperature sensor has failed.
What to do: The sensor needs replacing.
Home / Appliances / Boiler
Annual boiler tune-ups plus igniter, pump and control repair.
| Repair | Typical time | |
|---|---|---|
| Annual tune-uppopular | ~75 min · 3 mo warranty | |
| Igniter and flame sensor replacementpopular | ~60 min · 3 mo warranty | |
| Circulator pump replacement | ~90 min · 12 mo warranty | |
| Heat exchanger flush | ~90 min · 3 mo warranty | |
| Expansion tank service | ~45 min · 3 mo warranty | |
| Control board repair | ~120 min · 3 mo warranty |
Every visit starts with one flat service call. After the diagnosis you get an exact quote for parts and labor, and you decide before any work starts.
Troubleshooting
Error codes
Cause: The domestic hot water temperature sensor has failed.
What to do: The sensor needs replacing.
Cause: The combustion fan is not reaching the right speed.
What to do: The fan needs testing and replacing.
Cause: System pressure has dropped below the minimum.
What to do: Top the system up to 12–15 psi. If it keeps dropping, there is a leak.
Cause: The boiler overheated: low water flow, air in the system or a failed pump.
What to do: Check the pressure and bleed the radiators. If it returns, call a technician.
Cause: Gas pressure is weak or the ionization electrode is dirty.
What to do: Reset it. If it continues, the electrode needs cleaning.
Cause: The control sees a flame when the burner is off.
What to do: A technician must check the electrodes and control board.
Cause: A flame is still detected after the gas valve closed.
What to do: Turn off the gas supply and call a technician.
Cause: No gas supply or a failed igniter.
What to do: Check the gas valve is open and press Reset. If it repeats, call a technician.