Home / Washer repair / Samsung / front-load

Samsung front-load washer repair

Samsung front-load washers, including the VRT steam and AddWash lines. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.

From our service calls

What fails on the front-load

  • Drain pump and filter

    Water left in the drum and a drain code.

  • Door lock

    The door will not lock and the washer will not start.

  • Drum bearings

    A roar during spin.

  • Suspension

    Banging and an unbalanced code.

In Charleston

Lowcountry humidity means front-load door seals and dispensers mildew faster than in drier climates. Leave the door ajar between loads and wipe the seal weekly.

Owner tip: Use only HE detergent and clean the filter at the bottom front every few months.

Repairs

Common repairs for this washer

On the display

Samsung washer error codes

3C Samsung · Washer

Motor fault

Cause: The drive motor is overloaded or its sensor has failed.

What to do: Reduce the load and restart. If it returns, the motor needs service.

Needs a technician Book a repair
4C Samsung · Washer

No water coming in

Cause: A faucet is closed or the inlet hose is kinked.

What to do: Open the faucets, straighten the hoses and rinse the inlet screens. If nothing changes, the inlet valve is faulty.

You can check this yourself Book a repair
4C2 Samsung · Washer

Hot water on the cold inlet

Cause: The hot water hose is connected to the cold inlet.

What to do: Swap the inlet hoses so cold water feeds the cold inlet.

You can check this yourself Book a repair
5C Samsung · Washer

Water is not draining

Cause: The pump filter is full of debris or the pump has failed.

What to do: Drain the water through the emergency drain tube and clean the filter.

You can check this yourself Book a repair
9C1 Samsung · Washer

Voltage problem

Cause: The supply voltage is too low or too high.

What to do: Plug the washer directly into a wall outlet, not an extension cord. If it continues, have the outlet checked.

You can check this yourself Book a repair
AC Samsung · Washer

Communication error

Cause: The control boards have lost communication.

What to do: Unplug for 5 minutes. If it returns, the boards and wiring need testing.

Needs a technician Book a repair
HC Samsung · Washer

Heating fault

Cause: The heater or its sensor has failed.

What to do: The heater needs testing and replacing if faulty.

Needs a technician Book a repair
LC Samsung · Washer

Water leak detected

Cause: Water has reached the leak sensor in the base, or the drain hose is pushed too far into the standpipe.

What to do: Check the drain hose is not sealed into the pipe and look for leaks. If it returns, call a technician.

You can check this yourself Book a repair
OC Samsung · Washer

Overfill

Cause: The water level is too high: a faulty inlet valve or level sensor.

What to do: Turn off the water and unplug the washer. The valve and sensor need testing.

Needs a technician Book a repair

All Samsung washer codes

Call Book a repair