Too many suds
Cause: Too much detergent, or non-HE detergent in an HE washer.
What to do: Let the washer finish its rinse routine. Use only HE detergent and less of it.
Home / Washer repair / Maytag / Maytag Commercial Technology
Maytag top-load washers with an agitator and the heavier commercial-style drive. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.
From our service calls
The washer stops before spin.
Water left in the tub.
Slow or no fill.
Weak agitation.
In Charleston
Lowcountry humidity means front-load door seals and dispensers mildew faster than in drier climates. Leave the door ajar between loads and wipe the seal weekly.
Owner tip: Keep the lid area clean of detergent build-up so the lock closes fully.
Repairs
On the display
Cause: Too much detergent, or non-HE detergent in an HE washer.
What to do: Let the washer finish its rinse routine. Use only HE detergent and less of it.
Cause: The load has shifted to one side of the basket.
What to do: Open the lid, spread the laundry evenly and restart.
Cause: The main electronic control has an internal fault.
What to do: Unplug the washer for 2 minutes. If the code returns, the control board needs diagnostics.
Cause: The drain pump filter is clogged or the drain hose is kinked.
What to do: Unplug the washer, open the lower access panel and clean the pump filter. If the code returns, the pump needs replacing.
Cause: The water level sensor or its hose is faulty or disconnected.
What to do: The pressure hose and sensor need checking by a technician.
Cause: The door lock assembly is faulty or something is caught in the latch.
What to do: Make sure nothing is caught in the door and close it firmly. If the code stays, the lock needs replacing.
Cause: Weight on the lid or a failed lid lock is keeping it from releasing.
What to do: Remove anything on the lid and unplug for 2 minutes. If it stays locked, the lock needs replacing.
Cause: The main control and the motor control are not talking to each other.
What to do: Unplug for 2 minutes. If it returns, the wiring harness and boards need testing.
Cause: The motor can't reach the expected speed: overloaded basket, worn drive or faulty motor sensor.
What to do: Remove some laundry and restart. If it returns, the drive system needs service.
Cause: The shifter that switches between agitate and spin has failed or lost its signal.
What to do: The shifter assembly needs replacing.