Fill time too long
Cause: Water is entering too slowly or not at all.
What to do: Open the faucets fully and clean the inlet screens. If it returns, the inlet valve needs testing.
Home / Washer repair / Frigidaire / front-load and top-load
Frigidaire washers, sharing many parts with Electrolux. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.
From our service calls
Water left in the drum.
Will not start.
Roar during spin.
Slow fill.
In Charleston
Lowcountry humidity means front-load door seals and dispensers mildew faster than in drier climates. Leave the door ajar between loads and wipe the seal weekly.
Owner tip: Use HE detergent and clean the pump filter on front loaders.
Repairs
On the display
Cause: Water is entering too slowly or not at all.
What to do: Open the faucets fully and clean the inlet screens. If it returns, the inlet valve needs testing.
Cause: The drain pump is blocked or the drain hose is kinked.
What to do: Clean the pump filter and check the drain hose.
Cause: The pressure sensor reports the water level is too high.
What to do: Turn off the water. The inlet valve and pressure sensor need testing.
Cause: The door lock or its wiring is faulty.
What to do: Close the door firmly. If the code stays, the door lock needs replacing.
Cause: The motor tachometer signal is missing.
What to do: The motor and motor control need testing.