Home / Dryer repair / Whirlpool / electric dryer

Whirlpool electric dryer repair

Whirlpool electric dryers, including the widely sold 29-inch drum design shared with Kenmore, Maytag and Roper. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.

From our service calls

What fails on the electric dryer

  • Thermal fuse

    Blows when the vent is restricted and the dryer stops heating or starting.

  • Heating element

    The coil breaks and the drum turns but stays cold.

  • Drum rollers and idler

    Thumping and squealing.

  • Drum belt

    The motor runs but the drum stays still.

In Charleston

In humid Charleston summers a restricted vent shows up quickly as long drying times. Homes on the islands also need the outside vent flap checked for salt corrosion.

Owner tip: Clean the entire vent run once a year: almost every blown fuse on these dryers comes back to lint.

Repairs

Common repairs for this dryer

On the display

Whirlpool dryer error codes

AF Whirlpool · Dryer

Restricted airflow

Cause: The lint screen or the vent duct is blocked.

What to do: Clean the lint screen and check the vent hood outside. Have the duct cleaned if it is long.

You can check this yourself Book a repair
F01 Whirlpool · Dryer

Control board failure

Cause: The main electronic control has failed.

What to do: Unplug the dryer for 5 minutes. If the code returns, the board needs diagnostics.

Needs a technician Book a repair
F1 E1 Whirlpool · Dryer

Control board fault

Cause: The main electronic control has failed.

What to do: Unplug for 2 minutes. If it returns, the board needs diagnostics.

Needs a technician Book a repair
F2 E1 Whirlpool · Dryer

Stuck key

Cause: A button on the control panel is shorted or stuck.

What to do: Unplug for 2 minutes. If it returns, the user interface needs replacing.

You can check this yourself Book a repair
F4 E4 Whirlpool · Dryer

No heat detected

Cause: The heater circuit is open or one leg of power is missing.

What to do: Reset the breakers and clean the vent. If it returns, the heater circuit needs testing.

You can check this yourself Book a repair
L2 Whirlpool · Dryer

Low or missing line voltage

Cause: One leg of the 240 V supply is missing, usually a tripped breaker.

What to do: Reset both dryer breakers in the panel. If it returns, the outlet and cord need checking.

You can check this yourself Book a repair

All Whirlpool dryer codes

Call Book a repair