Home / Dryer repair / Samsung / electric and gas

Samsung electric and gas dryer repair

Samsung front-load dryers, matching the front-load and top-load washers. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.

From our service calls

What fails on the electric and gas

  • Heating element

    No heat on electric models.

  • Thermal fuse

    The dryer stops or will not heat after a vent restriction.

  • Drum rollers

    Thumping noise.

  • Moisture sensor

    Cycles end too early or run long.

In Charleston

In humid Charleston summers a restricted vent shows up quickly as long drying times. Homes on the islands also need the outside vent flap checked for salt corrosion.

Owner tip: Wipe the sensor bars inside the drum and clean the lint filter every load.

Repairs

Common repairs for this dryer

On the display

Samsung dryer error codes

9C1 Samsung · Dryer

Voltage problem

Cause: The supply voltage is out of range.

What to do: Have the outlet, breaker and cord checked.

Needs a technician Book a repair
FC Samsung · Dryer

Power frequency fault

Cause: The dryer detected an incorrect power frequency.

What to do: Unplug for 5 minutes. If it returns, the control board needs service.

Needs a technician Book a repair
HC Samsung · Dryer

Heating fault

Cause: The dryer is overheating, usually from a clogged vent.

What to do: Clean the lint filter and vent duct. If it returns, call a technician.

You can check this yourself Book a repair
HE Samsung · Dryer

Heating error

Cause: The heating element or a thermal fuse has failed.

What to do: Clean the lint filter and the vent. If the code stays, the heater needs replacing.

You can check this yourself Book a repair
bC Samsung · Dryer

Stuck button

Cause: A control panel button is jammed.

What to do: Press each button to free it. If the code stays, the panel needs service.

You can check this yourself Book a repair
dC Samsung · Dryer

Door open

Cause: The door is not latched or the door switch has failed.

What to do: Close the door firmly. If the code stays, the door switch needs replacing.

You can check this yourself Book a repair
tC Samsung · Dryer

Temperature sensor fault

Cause: The thermistor is faulty or the vent is clogged.

What to do: Clean the lint filter and vent. If it returns, the thermistor needs replacing.

You can check this yourself Book a repair

All Samsung dryer codes

Call Book a repair