User interface fault
Cause: The control panel is not communicating with the main control.
What to do: Switch off at the breaker for 5 minutes. If it returns, the panel or ribbon cable needs replacing.
Home / Appliances / Dishwasher
Professional repair of wash pumps, drain pumps, inlet valves and heaters.
| Repair | Typical time | |
|---|---|---|
| Circulation pump repairpopular | ~90 min · 3 mo warranty | |
| Drain pump replacementpopular | ~45 min · 3 mo warranty | |
| Water inlet valve replacement | ~45 min · 3 mo warranty | |
| Heating element replacement | ~60 min · 3 mo warranty | |
| Door latch and seal repair | ~40 min · 3 mo warranty | |
| Spray arm and filter cleaning | ~40 min · 1 mo warranty |
Every visit starts with one flat service call. After the diagnosis you get an exact quote for parts and labor, and you decide before any work starts.
Troubleshooting
Error codes
Cause: The control panel is not communicating with the main control.
What to do: Switch off at the breaker for 5 minutes. If it returns, the panel or ribbon cable needs replacing.
Cause: The thermistor and turbidity sensor is open or shorted.
What to do: The sensor needs replacing.
Cause: The control did not see the door open and close.
What to do: Open and close the door firmly, then press Start. If it returns, the latch needs replacing.
Cause: The inlet valve has an electrical fault.
What to do: The inlet valve needs replacing.
Cause: Too much detergent, hand dish soap, or not enough water.
What to do: Use only dishwasher detergent and check the water supply is fully open.
Cause: Water in the base pan has lifted the overfill float.
What to do: Turn off the water supply. The leak must be found and fixed.
Cause: The heating element or its circuit has failed.
What to do: The heater needs testing and replacing.
Cause: The drain hose is kinked or the drain path is clogged.
What to do: Clean the filter, check the hose and the garbage disposal knockout plug.