Humidity sensor fault
Cause: The moisture sensor has failed.
What to do: The sensor needs replacing.
Home / Charleston (Downtown) / Dryer repair
Gas and electric dryers: heating, drum, airflow and control repairs. We reach Charleston (Downtown) (29401, 29403, 29424, 29425) in about 30 minutes.
What we hear most in Charleston (Downtown)
| Repair | Typical time | |
|---|---|---|
| Thermal fuse and thermostat replacement | ~40 min · 3 mo warranty | |
| Vent and lint path cleaning | ~45 min · 1 mo warranty | |
| Moisture sensor repair | ~45 min · 3 mo warranty | |
| Heating element replacement | ~60 min · 3 mo warranty | |
| Gas igniter replacement | ~50 min · 3 mo warranty | |
| Belt and roller replacement | ~70 min · 3 mo warranty |
Code on the display?
Cause: The moisture sensor has failed.
What to do: The sensor needs replacing.
Cause: Power was interrupted during the cycle.
What to do: Press Start to resume.
Cause: The power cord is connected to the wrong terminals or the supply voltage is wrong.
What to do: An electrician or technician must check the cord and outlet.
Cause: The vent duct is clogged with lint or crushed behind the dryer.
What to do: Clean the lint filter and the full length of the vent duct to the outside.
Cause: The vent duct is heavily clogged with lint or crushed.
What to do: Clean the full vent run to the outside before using the dryer again.
Cause: The vent is almost completely blocked. This is a fire risk.
What to do: Stop using the dryer until the vent has been cleaned.
Typically about 30 minutes after we confirm the booking. You choose a three-hour arrival window and the technician calls before setting off.
One flat service call covers the trip to Charleston (Downtown) and a full diagnosis. You then get an exact quote for parts and labor before any work starts.