Home / Water heater repair / Rheem / tankless

Rheem tankless water heater repair

Rheem tankless water heaters. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.

From our service calls

What fails on the tankless

  • Scale

    Error codes and fluctuating temperature.

  • Ignition

    Will not fire.

  • Flow sensor

    Will not start at low flow.

  • Venting

    Shut-down codes.

In Charleston

Many Lowcountry homes keep the water heater in a garage or attic, where heat and humidity speed up corrosion. Have the anode rod checked every few years.

Owner tip: Descale yearly in hard water areas.

Repairs

Common repairs for this water heater

On the display

Rheem water heater error codes

11 Rheem · Water heater

No ignition

Cause: No gas supply, air in the gas line or a failed igniter.

What to do: Check the gas is on, then turn the unit off and on. If it repeats, call a technician.

You can check this yourself Book a repair
12 Rheem · Water heater

Flame loss

Cause: The flame went out during operation.

What to do: Check the gas supply and vent. If it repeats, the flame rod needs cleaning.

Needs a technician Book a repair
13 Rheem · Water heater

Poor combustion

Cause: The burner is not burning correctly: wrong gas pressure or blocked vent.

What to do: A technician must check gas pressure and venting.

Needs a technician Book a repair
1L Rheem · Water heater

Scale build-up

Cause: Limescale has built up in the heat exchanger.

What to do: The unit needs a descaling flush.

Needs a technician Book a repair
29 Rheem · Water heater

Condensate drain blocked

Cause: The neutralizer or condensate line is clogged.

What to do: Check the condensate line for kinks or blockages.

You can check this yourself Book a repair
99 Rheem · Water heater

Blocked exhaust

Cause: The vent is blocked or the heat exchanger is restricted.

What to do: Check the vent outside. If it is clear, call a technician.

You can check this yourself Book a repair
P1 Rheem · Water heater

Not enough water flow

Cause: The flow is below the minimum needed to fire the burner.

What to do: Open the hot tap further and clean the inlet water filter.

You can check this yourself Book a repair

All Rheem water heater codes

Call Book a repair