Ignition failure
Cause: No gas supply or a failed igniter.
What to do: Check the gas valve is open and press Reset. If it repeats, call a technician.
Home / Boiler repair / Navien / combi boiler
Navien combi boilers that provide heating and hot water. We repair them at your home across Charleston, North Charleston, Mount Pleasant, Summerville and the Lowcountry.
From our service calls
Boiler locks out.
Will not fire.
Radiators stay cold.
Drain blockage codes.
In Charleston
Boilers are less common in the Lowcountry, but we service the hydronic and combi systems found in many older Charleston homes.
Owner tip: Check the pressure gauge regularly.
Repairs
On the display
Cause: No gas supply or a failed igniter.
What to do: Check the gas valve is open and press Reset. If it repeats, call a technician.
Cause: The flame went out during operation.
What to do: Reset the boiler. If it continues, the flame rod and gas pressure need checking.
Cause: Poor circulation or a blocked heat exchanger.
What to do: Turn the boiler off and let it cool. The pump and heat exchanger need checking.
Cause: The air intake or exhaust is blocked.
What to do: Check the vent terminations outside for blockages.
Cause: The heating supply thermistor has failed.
What to do: The sensor needs replacing.
Cause: The heating return thermistor has failed.
What to do: The sensor needs replacing.
Cause: System pressure has dropped — often a slow leak or a failed fill valve.
What to do: Check the pressure gauge. If it reads under 12 psi, the system needs refilling and leak-checking.
Cause: The make-up water valve could not bring the pressure up.
What to do: Check the water supply to the boiler is open. If it returns, call a technician.
Cause: System pressure is over the limit: failed fill valve or expansion tank.
What to do: Do not keep resetting it. The expansion tank and fill valve need checking.