Oven sensor open or shorted
Cause: The temperature sensor or its wiring has failed.
What to do: The sensor needs testing and replacing.
Home / Problems / Oven & range / Oven not heating
An oven that will not heat usually has a failed igniter on gas models or a broken bake element on electric models.
Most likely first
It glows but not hot enough to open the gas valve.
A visible break or blister on the coil.
The control cannot read the oven temperature.
The oven cuts out after overheating.
The relays no longer send power.
In Charleston
Salt air near Folly Beach, Isle of Palms and the other islands can corrode burner and igniter parts over time. A slow-lighting burner is worth a check before it fails.
Safe checks before you book
When to call us: Call us if the igniter glows without lighting, the element is damaged, or the oven shows a sensor code.
Repairs that fix it
Shows a code?
Cause: The temperature sensor or its wiring has failed.
What to do: The sensor needs testing and replacing.
Cause: The temperature sensor or the control is faulty.
What to do: Turn the oven off and let it cool. The sensor and control need testing.
Cause: The temperature sensor or its wiring has failed.
What to do: The sensor needs testing and replacing.
Cause: The sensor detected overheating.
What to do: Turn the oven off and let it cool. If it returns, call a technician.
Cause: The oven did not reach temperature: failed igniter, element or sensor.
What to do: The heating circuit needs testing.
Cause: The oven temperature went too high.
What to do: Turn the oven off and let it cool. Do not use it until it has been checked.
Cause: The temperature sensor is disconnected or failed.
What to do: The sensor needs replacing.
Cause: The oven did not heat up in time: failed igniter, element or relay.
What to do: The heating circuit needs testing.
An oven that will not heat usually has a failed igniter on gas models or a broken bake element on electric models.
On electric ovens look at the bake element for breaks. On gas ovens watch the igniter: it should light within about 90 seconds. Check the breaker.
Call us if the igniter glows without lighting, the element is damaged, or the oven shows a sensor code.
One flat service call covers the trip and a full diagnosis. You get an exact quote for parts and labor before any work starts.